Wireless IAQ Monitor [Mini IAQ Profile]

The Mini IAQ Profile system has been designed to give a visual representation of indoor air quality in buildings, as part of the buildings management standards in relation to conditions such as Sick Building Syndrome. Since a great number of units can be networked, the system can show precise changes in concentration of selected IAQ parameters in various locations over time. The Mini IAQ Profile Monitor system enables the user to control and run several different wireless IAQ sampling units — all communicating together via the sophisticated and reliable ZigBee wireless mesh system. The mesh network system is cost effective, easy to install and simple to use: the nodes which make up the mesh automatically configure the optimal signal route. Other advantages of a wireless mesh system is that it is self-healing meaning that the network can still operate even when a node breaks down or a connection goes bad. As a result, a very reliable network is formed. The size of the wireless mesh can be easily extended by simply adding new Mini IAQ Monitor units or even the larger IAQ monitor units, as each one is also a router for it's neighbors.

In areas where no IAQ monitoring is required then dedicated "Repeater" nodes can be used for the same purpose. Power Amplified Wireless Modules are also available, these have more powerful antennae to considerably increase the transmission distance and consequently reducing the need for repeaters and simplifying the network.

The Mini IAQ Unit is able to monitor temperature and humidity as well as up to 3 different IAQ parameters. The Manager PC connects to the mesh network via a special node which is capable of receiving and transmitting information to each IAQ Profile Monitor. The Manager PC can view, run and control the real time monitoring and data logging of air quality in a building at the click of a button. The PPMonitor software enables the data to be viewed graphically, produce reports and statistical data, run schedules as well as alarm functions and notifications for more effective and economical building management. It is possible to set up an Ethernet Access Point (EAP) to the wireless network which allows the wireless modules to be accessed from any location world-wide via the Internet provided the necessary internet address, firewalls and gateways are enabled on the local network.

The Mini IAQ Profile Monitor incorporates a variety of advanced gas sensor technologies to monitor the target gases including NDIR, PID and Electrochemical and is available in four main configurations, all of which can be networked together.

 

Configuration 1	Configuration 2	Configuration 3	Configuration 4
Mini Wireless Htv or Glutaraldemeter	Mini Wireless Sensor	Mini Temp & Humidity	Mini Alarm system
A wireless Htv or Glutaraldemeter solution, which can be used to monitor airborne formaldehyde or Glutaraldehyde levels in a building. Also provides monitoring of temperature and humidity levels within the area. Additional relay option to allow control of alarm and airconditioning systems.	Built in temperature and humidity module, and available with up to 3 IAQ parameter sensors. These include but are not limited to: Nitrogen Dioxide, Carbon Monoxide, Carbon Dioxide, Sulphur Dioxide, Total Volatile Organic Compounds, Ozone, Ammonia, Methane, Smoke, Motion Sensor	Allows for monitoring of temperature and humidity levels within a building. Can be networked with other mini wireless units and IAQ monitors on the Zigbee mesh network.	A dedicated wireless system with 3 inbuilt relays to control various outputs such as audible/ visual alarm systems and other third-party systems. Also provides monitoring of temperature and humidity levels within the area. Can be networked with other mini wireless units and IAQ monitors on the Zigbee mesh network

 

Specifications

Mains Powered	12v DC via external DC adaptor with 2.5mm diameter jack plug
Operating Range	0-30℃ 15-90%RH
Dimensions	145mm x 145mm x 55mm (Houses 3 IAQ parameter sensors as well as temperature and humidity)
Easy to Install	Simply plug the included USB module into the PC and connect up the power to the IAQ monitor on the wall. The IAQ Monitor Units are easily wall mounted via VESA standard bracket
Software	Built in PPMonitor Wireless exclusive management software for Management PC ***Requires Windows XP Professional Edition or Windows 7 Professional Edition***
Sampling Rate	Up to 3 parameter data values every minute